Barco R9002120 manual Controlling, Battery installation in the RCU

Controlling

4 CONTROLLING

Caution : Do not display a stationary image with full brightness and contrast for longer than 20 min., otherwise you risk damage to the CRT's.

Battery installation in the RCU.

A new battery is delivered inside the plastic bag with the power cord. Before using the RCU, install first the battery.

Remove the battery cover on the backside of the remote control by pushing the indicated handle a little to the bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).

Insert the new 9 V battery (E-block type, e.g. 6F22S or equivalent) in the lower compartment and connect the battery to the contact plate.

Insert the battery into the lower compartment and put the cover back.

	Insert here,
	behind the
	plastic cover, the	fig.1
	'Insert card for
	RCU'. You can
Contact	cut out this card
plate	on one of the
	last pages of this
	manual.

Battery

fig.2

310a.DRW

5975977 BARCODATA 708 260597 4-1