Barco R9002120 How to program an address into the RCU?, Input selection, Press button, Source No

Controlling

To continue using the RCU, it is necessary to enter an address with the digit buttons (address between 0 and 9). For example : if the Address key displays projector address 003, the press "3" digit button on the RCU to set the RCU's address to match the projector's address. Do not press digit 003. This will address the remote to '0' and control all projectors in the room.

How to program an address into the RCU?

Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address with the digit buttons. That address can be any digit between 0 and 9.

Input selection

Source No	Projector input	Press button
1	Comp. Video	1
2	S-Video/Comp. Video1	2
3	RGBS or RGsB	3
3	RGB3S or RG3sB	4
3	(R-Y)Y(B-Y)S or
	(R-Y)Ys(B-Y)	5
3	(R-Y)Y(B-Y)3S or
	(R-Y)Y3s(B-Y)	6

Two possible ways of selecting an input :

a)With the digit buttons on the RCU, it is possible to select one of the four input sources, Video, S-Video, RGsB or RGBS, RG3sB or RGB3S, (R-Y)Ys(B-Y) or (R-Y)Y(B-Y)S, (R-Y)Y3s(B-Y) or (R-Y)Y(B- Y)3S.

b)With the local keypad :

press first the ADJUST key to display the General access menu.

control disk to the left or to the right to move the cursor to the left and to the right.

Press ENTER to confirm your selection.

When a valid and available source is selected, there will be informa- tion displayed on the screen about that source. This information includes :

-Source number

-Horizontal frequency

-Vertical frequency

Source 2

Fh= 15.6 kHz

Fv= 50 Hz

When the entry is a non valid source number, a warning appears on the screen : 'input not available'.

WARNING

input not available

When a valid source number is selected, the projector will display this source or it will wait on the selected source number until the source becomes available. A message 'source not available' will be dis- played for a short time.

ADJUSTEXIT

STANDBYENTER

Use the control disk to highlight the desired source number. Push the control disk up or down to move the cursor up and down, push the

	GENERAL ACCESS
		SHARPNESS
		TINT
5	6	COLOR
3	4	BRIGHTNESS
1	2	CONTRAST

Enter ADJUST

Select with	,
	or
then <ENTER>.

<EXIT> to return

WARNING

source not available

5975977 BARCODATA 708 260597 4-3