LINESHARE PRO
NOTE
Settings in this function do not affect the settings in the Dual Tone Assignments function.
Dual Tone Detection is factory- preset as follows (the first number is the corresponding port number; the second number is 0 for OFF, or 1 for ON):
1 1 * (Port 1 = ON)
2 1 * (Port 2 = ON)
3 1 * (Port 3 = ON)
4 1 * (Port 4 = ON)
To change one port to ignore dual tones, enter the programming mode and press the following on your tone phone:
2 2 Dual Tone Detection
The desired port selection
0 Turn OFF
*End programming sequence (3 beeps indicate correct entry)
(Optional entries for additional changes)
*Save changes and exit programming
To change all ports to ignore dual tones, enter the programming mode and press the following on your tone phone:
2 2 Dual Tone Detection
0 Select all ports 1 through 4
0 0 0 0 All ports OFF
*End programming sequence (3 beeps indicate correct entry)
(Optional entries for additional changes)
*Save changes and exit programming
[2][3] Protocol Tone Access Signal Assignment
Protocol Tone Access Signal Assignment allows you to define the protocol tone access signal for each of the ports. You can enter a protocol tone access signal of
45
