To select different protocol tones for all ports, press the following on your tone phone:
2 3 Protocol Tone Access Signal
0 Select all ports 1 through 4
The desired new protocol tones
*End programming sequence (3 beeps indicate correct entry)
(Optional entries for additional changes)
*Save changes and exit programming
NOTE
You must enter all four digits to associate a tone to each port. If you enter only one or two numbers, the Lineshare Pro will produce an error tone.
Do not assign a single protocol tone to more than one port. If you inadvertently assign a protocol tone to more than one port, the Lineshare Pro will produce an error tone.
LINESHARE PRO
[3] Cascade Port Order
Cascade Port Order operates only when the Lineshare Pro is configured in the
This function sets the assigned order for the No Answer Cascade and Answer/Disconnect Cascade features.
The sequence of the Cascade Port Order can be set to default to any of the Lineshare Pro ports. The Cascade Port Order is
To change the Cascade Port Order to reverse its default order
(4 3 2 1), enter the programming mode and press the following on your tone phone:
3Cascade Port Order
43 2 1 The desired new cascade order
*End programming sequence (3 beeps indicate correct entry)
(Optional entries for additional changes)
*Save changes and exit programming
47
