Black Box FX150A manual Protocol Tone Access Signal Detection, Dual Tone Detection

LINESHARE PRO

[2][1] Protocol Tone Access Signal Detection

Protocol Tone Access Signal Detection allows you to turn ON or OFF each port’s ability to detect single-frequency routing tones. Setting the options for this function can be performed in two ways:

•Setting an individual port ON or OFF.

•Setting all ports ON or OFF in one programming sequence.

The Protocol Tone Access Signal Detection is factory-preset as follows (the first number is the corresponding port number; the second number is 0 for OFF, or 1 for ON):

1 0 * (Port 1 = OFF)

2 0 * (Port 2 = OFF)

3 1 * (Port 3 = ON)

4 1 * (Port 4 = ON)

To change one port to detect single-frequency tones, enter the programming mode and press the following on your tone phone:

2 1 Protocol Tone Access Signal Detection

The desired port selection (1-4)

1 Turn ON

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

To change all ports to detect

single frequency tones, enter the programming mode and press the following on your tone phone:

2 1 Protocol Tone Access Signal Detection

0 Select all ports 1 through 4

1 1 1 1 All ports ON

*End programming sequence (3 beeps indicate correct entry)

(Optional entries for additional changes)

*Save changes and exit programming

[2][2] Dual Tone Detection

Dual Tone Detection allows you to turn ON or OFF each port’s ability to detect dual tones (access codes). Setting the options for this function can be performed in two ways.

•Setting an individual port ON or OFF.

•Setting all ports ON or OFF in one programming sequence.

44