Chapter 6: OSD Configuration
6.3 Factory Reset/Defaults
Navigate with the arrow keys in the CONFIGURATION menu to the Factory Reset
Press ENTER/SELECT to open the DEFAULTS window.
Figure
Use this function to reset the current settings of ServSwitch 4site Flex to the factory default configuration. All four input EDIDs are also reset to their default values.
If necessary, save your current settings before using the DEFAULTS command. Execution of this command results in a complete reset and reboot of ServSwitch 4site Flex with factory defaults.
FACTORY DEFAULTS: |
|
|
SYSTEM | HOTKEY | = Multiple Hotkey / Hotkey = Ctrl + Alt |
| HOTMOUSE | = ON / Hotmouse timeout = 5 sec. |
| QUAD MODE | = Channel selection timeout = 5 sec. |
| WIN MODE | = Border width = 0 sec. |
|
| Active channel= 255,255,0 |
|
| Active channel= 255,136,0 |
| OSD POSITION | = centered |
| OSD LANGUAGE | = English |
| SECURITY | = None (security level = 0) |
| DISABLE CHANNEL | = All four channels are active |
| CONTROL | = Off |
MODE | CURRENT | = Active channel = 1, quad |
| START | = Active channel = 1, quad |
| > PIP Size | = 15 % Zoom factor = 1 |
|
| Display mode = triple Active channel = gap; |
|
| Offset from top = 0 % |
| >WIN | = Channel: 1, Mode:win1, Position settings depend on the |
|
| source, Aspect ratio: enabled |
Page 45 |
