Self Help - Oven
OVEN PROBLEM | POSSIBLE CAUSES & SUGGESTED |
| SOLUTIONS |
|
|
The oven mode or temperature selected or the | The knob was turned too rapidly. Turn knob slowly until |
numbers selected do not appear in the display | correct wording or temperature appears. Review manual |
| instructions when setting clock, timer, or |
|
|
Oven door is locked and will not release, even | Turn the oven off at the circuit breaker and wait 5 |
after cooling | minutes. Turn breaker back on. The oven should reset |
| itself and will be operable. |
|
|
Oven is not heating | Check the circuit breaker or fuse box to your house. |
| Make sure there is proper electrical power to the oven. |
| Make sure the oven temperature has been selected. |
|
|
Oven is not cooking evenly | Check oven calibration. Adjust calibration if necessary |
| (see Oven Temperature Offset, Page 7). Refer to cooking |
| charts for recommended rack position. Always reduce |
| recipe temperature by 25°F when baking with Convection |
| Bake mode. |
|
|
Oven temperature is too hot or too cold | The oven thermostat needs adjustment. See Oven |
| Temperature Offset, Page 7. |
|
|
Oven light is not working properly | Replace or reinsert the light bulb if loose or defective. |
| Touching the bulb with fingers may cause the bulb to |
| burn out. |
|
|
Oven light stays on | Check for obstruction in oven door. Check to see if hinge |
| is bent. |
|
|
Cannot remove lens cover on light | There may be soil |
| lens cover area with a clean dry towel prior to attempting |
| to remove the lens cover. |
|
|
Oven will not | Allow the oven to cool before running |
| wipe out loose soils or heavy spillovers before running |
| |
| hour |
| Page 24. |
|
|
Clock and timer are not working properly | Make sure there is proper electrical power to the oven. |
| See the Clock and Timer sections, Pages 5 and 18. |
|
|
Porcelain in oven chips | When oven racks are removed and replaced, always tilt |
| racks upward and do not force them to avoid chipping |
| the porcelain. |
“F” and a number appears in display and | This is a fault code. If a “F” code flashes, press OFF to |
control beeps continuously | clear the display and stop beeping. Reset oven if |
| necessary. If fault code remains and beep continues, |
| record fault code number, cancel oven and call |
| authorized service technician. |
|
|
With a new range there is a strong odor | This is normal with a new range and will disappear after |
when oven is turned on | a few uses. Operating the |
| |
|
|
Self Help
English • 29