BM 2610025580
Assembly
Attaching loose parts
| To avoid | possible | injury, |
|
| |
! WARNING |
|
| ||||
FIG. 1 | Hook | |||||
disconnect | plug from | power | ||||
|
|
|
|
| ||
|
|
|
|
|
| |
source before performing any assembly, |
|
| ||||
adjustments or repairs. |
|
|
| Grommet |
Storing the 5mm Hex Key
There is a storage location on the saw to store the 5mm hex key. Insert the short leg of the hex key through the rubber grommet as shown. Rotate long leg under hook (see figure 1).
NOTE: The 5mm hex key is needed to change the blade and to make tool adjustments.
Attaching 60˚ Auxiliary clamp hole
1.Position the 60˚ auxiliary clamp hole as shown in figure 2.
2. Insert the screws provided into holes and tighten with Philips screwdriver.
FIG. 2
The 60˚ auxiliary clamp hole is used to appropriately clamp material at angles from 55 ˚to 60˚ right see page 25 for clamping instructions.
Auxiliary
Clamp Hole
Mounting
Screws
5mm Hex Key
12.