
BM 2610025580
Getting To Know Your Miter Saw
39
35
36
37
38
32
41
42
| 33 |
34 | 40 |
|
NOTE: To view items 20 through 30, see page 8.
20.Base Extension Clamping levers – Lock the base extensions at the desired positions.
21.Sliding Base Extensions – Provide extra work support. Useful when cutting long workpieces.
22.Rubber Deflector – Attaches to bottom of chute. Deflects dust into the chute.
23.Dust Chute – Directs sawdust up and through the elbow and to the bag.
24.Dust Bag – Has a zipper at the bottom. Bag can be uncoupled for emptying.
25.Slide Rail lock Knob – The slide rail lock knob locks the slide rail when you are not making slide cuts and when you are transporting the saw.
26.Clamp – Use to hold the workpiece to the table and base – insert into clamp post location (item 32).
27.Depth Stop Screw – Turn the knob end to adjust the blade depth for cutting grooves.
28.Depth Stop plate – Plate can be swung out to limit the depth of the blade travel.
29.60˚ Auxiliary Clamp Hole – used to appropriately clamp material at angles from 55˚to 60˚ right.
30.left Bevel Stop indicator – allows you to set the most common bevel stops 0°, 22.5°, 33.9°, 45° and 47° Left.
31.Blade Bolt Cover plate – Covers the blade bolt.
32.Bevel Scale and pointers – Scale is large to allow user to easily read bevel angles. Pointer indicates what the current angle is.
33.Clamp post locations – Two vertical post holes in the base provided to insert the clamp (item 26).
34.Miter Detent plate Screws – Four screws accessible through holes in the miter scale. These screws are loosened when adjusting position of the detent plate.
35.Arbor lock – Press arbor lock button to keep blade from rotating when loosening or tightening arbor bolt during blade removal or installation.
36.Motor Cap – Provides access for inspecting and replacing brushes.
37.Head Assembly lock pin – Used to lock the head assembly in the lower position for transporting.
38.Bevel lock lever – The
39.Top Carrying Handle – Used for lifting and transporting of saw.
40.
41.
42.5mm hex key – Used to change the blade and to make tool adjustments.
9.