Chest Exercises

 

23

 

 

Decline Bench Press Shoulder Horizontal Adduction (with elbow extension)

START

FINISH

Muscles worked: The entire chest muscle (pectoralis major) is emphasized. It also involves the front shoulder muscles (anterior deltoid, a portion of the middle deltoid) and the triceps, which are located on the back of the upper arms.

Pulley position: Wide or narrow (Wide offers a greater challenge throughout the entire range on specific movements, especially at the top of these movements. This can make these exercises even more effective. However, when both pulley positions are listed as options, do not attempt to use the same weight for each position).

Starting position:

Seated in the incline position, reach straight behind your body, grasp the handles with an overhand grip and bend your elbows until your hands are near your chest. Rotate upper arms away from your torso so your elbows point outward and your palms face forward.

Make sure cables travel underneath your arms, not over your arms.

Keeping knees bent and feet flat on the floor, lay your head back against the bench and straighten your arms to the front.

From this position, lower your arms 10-15 degrees (cables touching the bottom of your arms/shoulders) below the regular bench press position (cables lying along the back of your arm and center of the shoulders).

Be sure your arms are directly in-line with the cables, palms facing forward and wrists straight. If the cables are "below" the arms, the arms are too low.

Raise your chest and slightly "pinch" your shoulder blades together. Maintain a very slight, comfortable arch in your lower back.

Motion:

Slowly move your elbows outward, simultaneously bending your arms so that your forearms remain parallel to each other and the hands remain over the elbows throughout the movement. From the side view it should appear as if the forearms are in line with the cables at all times.

Stop when your upper arms are approximately straight out to the sides (your elbows will be level with your shoulders or slightly below).

Then, slowly press forward, moving the hands toward the center, and return to the starting position with arms straight to the front at shoulder width and in line with the cables. Keep your chest muscles tightened during the entire motion.

Optional motions:

Bilateral movement - both arms pressing forward at the same time.

Unilateral movement – performing all reps with one arm before moving to the next.

Alternating – performing one rep on one side and then the next rep on the other side.

Simultaneously alternating – both arms moving, although in opposite directions (one pressing while the other is returning).

Key points:

The upper arms will be 60-90 degrees from the sides of your torso at the bottom of the movement and slightly less than 90 degrees from the front of your torso at the top.

Limit the range of motion so your elbows travel only slightly behind your shoulders —

if at all.

Resisted Punch Shoulder Flexion, Elbow Extension and Scapular Protraction

START

Muscles worked: This exercise involves the entire chest muscle, the front shoulder muscles (anterior deltoid, a portion of the middle deltoid) and the triceps, located on the back of the upper arms. The goal however, is not any specific muscle group. It is to be used with very light resistance for an endurance activity.

Pulley position: Narrow only.

Starting position:

With the bench flat and locked in the back position against the lat tower, sit facing away from the Power Rods®.

Reach straight behind your body, grasp the handles with an overhand grip so that the cable will lay between your arm and your torso.

Bend your elbows until your hands are level with your waistline and your palms are facing your torso.

Maintain erect posture.

Motion:

Using a moderate speed and light weight, rotate your trunk and press one arm forward to full extension, allowing the shoulder blade to move forward at the end of the punch.

Return that arm to the starting position — under control — and repeat with the

other arm.

As an alternative to punching straight forward you may also punch upward at an angle in line with the cable.

Optional motions:

Bilateral movement – both arms pressing forward at the same time.

Unilateral movement – performing all reps with one arm before moving to the next.

Alternating – performing one rep on one side and then the next rep on the other side.

Simultaneously alternating – both arms moving, although in opposite directions (one pressing while the other is returning).

Key points:

Maintain an upright, erect posture as your trunk twists/rotates with the punch.

It is important to note that "sport specific" movements will not necessarily improve the skill associated with a sport.

FINISH

Page 23
Image 23
Bowflex 51370 manual If at all, Pulley position Narrow only Starting position

51370 specifications

The Bowflex 51370 is a versatile and innovative piece of fitness equipment that has gained popularity among home gym enthusiasts. Designed to enhance strength training while minimizing the need for multiple machines, this compact system combines a range of features and technologies to provide an effective workout experience.

One of the standout characteristics of the Bowflex 51370 is its unique Power Rod technology. This patented resistance system delivers a smooth and consistent resistance throughout the entire range of motion, allowing users to perform a variety of exercises with confidence. With adjustable resistance levels, users can customize their workouts to match their fitness goals, whether it's building strength, increasing endurance, or toning muscles.

The Bowflex 51370 offers adjustable resistance starting at 5 pounds and going up to 210 pounds, making it suitable for beginners and advanced users alike. The ability to increase resistance in small increments allows for gradual and safe progression, which is essential for long-term strength development.

Another key feature of this home gym system is its compact design. Unlike traditional weight machines that occupy a significant amount of space, the Bowflex 51370 is designed to fit in smaller workout areas. Its folding design allows users to easily store it away when not in use, making it an ideal solution for those with limited space.

The Bowflex 51370 comes with a variety of accessories, including a lat bar, squat bar, and ankle cuffs, enabling users to perform over 70 exercises targeting different muscle groups. This versatility makes it possible to enjoy a complete full-body workout without the need for separate machines.

Moreover, the included user guide provides a wealth of exercise options and routines, helping users to stay motivated and make the most of their training sessions. This is complemented by Bowflex's online resources, which offer video tutorials and workout plans tailored to various fitness levels.

In terms of build quality, the Bowflex 51370 is constructed from durable materials designed to withstand rigorous use. The sturdy frame ensures stability and safety during workouts, while the comfortable padding enhances user comfort.

In conclusion, the Bowflex 51370 stands out as a comprehensive fitness solution that merges advanced technology with user-friendly features. Its compact size, adjustable resistance, and diverse exercise options make it an excellent choice for anyone looking to achieve their fitness goals from the comfort of their home.