￿®®l›c‹àÍ￿_ÍÍ-￿"￿￿￿Í￿AÃc

3&0&,$￿&DUG￿,QVWDOODWLRQ

The PCMCIA card slot is a factory-installed option. If your printer has this option, you may install or change the card at any time. Use the following procedure to install a PCMCIA card.

CAUTION: Observe proper electrostatic safety precautions when handling any static-sensitive components such as printed circuit boards and printheads.

1.Turn the AC power switch in the Off (2) position and disconnect the AC power cord. Disconnect the data cables.

2.Refer to Figure 41. Remove and retain the screw and the option card shield from the rear of the printer.

3.If you are replacing the card, press the card eject button and slide the card out of the slot.

4.Slide the new card into the slot far enough that the eject button pops out.

5.Reinstall the option card shield and secure it with the screw.

6.Reconnect the AC power cord and all data cables.

7.Press and hold the FEED key while placing the power switch in the On (,) position.

8.Verify the presence of additional memory or optional fonts by checking the information on the configuration label that was printed during the power on sequence.

9.The printer is now ready to operate with the additional memory or font option.

Bradyprinter 200M-e and 200M-e 300 User’s Guide

103