$ODEHOIRUPDWZDVVHQWWRWKHSULQWHU6HYHUDOODEHOVSULQWWKHQ WKHSULQWHUVNLSVPLVSODFHVPLVVHVRUGLVWRUWVWKHLPDJHRQWKH
ODEHO
Problem | Solution | |
The host is set to EPP parallel | Change the settings on the computer host to standard | |
communications. | parallel communications. | |
|
| |
| Ensure that the flow control settings match. | |
|
| |
The serial communication settings are | Check the communication cable length. See page 22 for | |
requirements. | ||
incorrect. |
| |
Check the printer driver or software communications | ||
| ||
| settings (if applicable). | |
|
|
$ODEHOIRUPDWZDVVHQWWRWKHSULQWHUEXWQRWUHFRJQL]HG7KH '$7$OLJKWIODVKHVEXWQRSULQWLQJRFFXUV
Problem | Solution |
The prefix and delimiter characters set in the | Verify the prefix and delimiter characters. See page 55. |
printer do not match the ones in the label |
|
format. |
|
|
|
| Ensure that ZPL is being used. |
Incorrect data is being sent to the printer. |
|
Check the communication settings on the computer. | |
| Ensure that they match the printer settings. |
|
|
7KHSULQWHUIDLOVWRFDOLEUDWHRUGHWHFWWKHWRSRIWKHODEHO
Problem | Solution |
The printer was not calibrated for the label | Perform the calibration procedure on page 17. |
being used. |
|
|
|
The printer is configured for continuous | Set the media type to |
media. |
|
|
|
The driver or software configuration is not set | As driver or software settings produce ZPL commands that |
correctly. | can overwrite the printer configuration, check the driver or |
| software |
|
|
76 | Bradyprinter |