(Peel option required)
Refer to Figure 19.
1.Press the printhead open lever. The printhead assembly springs up.
2.Slide out the media supply guide as far from the printer frame as possible.
3.Place the roll of media on the media supply hanger.
4.Slide in the media supply guide so that it just touches, but does not restrict, the edge of the roll.
5.Feed the media under the inner media guide in the print mechanism.
6.Pull approximately 36" (915 mm) of media through the front of the printer.
7.Ensure that the media is against the inner media guide. Then, slide in the outer media guide so that it just touches, but does not restrict, the edge of the media.
8.Close the printhead assembly.
9.Remove the hook from the
10.Remove several labels from the media backing and then wind the backing
NOTE: If your printer has a peel with a rewind option, then you need to remove the rewind plate and store it on the mounting screw on the inside of the front panel before proceeding to step #9 above.
Bradyprinter | 33 |