Brother CM100DM Installing and Uninstalling the Holder, Trial Cutting, Turning On the Machine

bCheck the thickness of the material, and then adjust the blade extension. See “Appropriate Blade Extension” on page 18.

The larger the holder scale setting, the further the blade extends.

ab

aTurn to the left to decrease the blade extension.

bTurn to the right to increase the blade extension.

Installing and Uninstalling the Holder

Install the holder in the machine.

aPress in the operation panel to turn on the machine.

For details, see “Turning On/Off the Machine” on page 10.

bIf the holder lock lever is not raised, raise it.

The holder cannot be installed if the lever is lowered.

a

aHolder lock lever

cGrasp the holder grip, and then insert the holder into the carriage.

a

1

aGrip

dPush down on the holder lock lever.

Firmly push down until the holder is locked in place.

eReverse the installation procedure to uninstall the holder.

Note

•After removing the blade holder from the machine or when storing it, store the blade tip within the holder.

Trial Cutting

Make sure that the blade extension is appropriate for the material. Using the same material to cut or draw on in your project, perform trial cutting.

■Turning On the Machine

Press in the operation panel to turn on the machine.

•For details, see “Turning On/Off the Machine” on page 10.

■Setting the Holder

Install the cutting blade holder into the carriage of the machine.

•For details, see “Installing and Uninstalling the Holder” on page 19.

19