Brother CM100DM operation manual Tutorial 2 Cutting Advanced Patterns, Loading the Mat

XTouch the pattern to be deleted in the screen. To delete multiple patterns, use the function for selecting multiple patterns. For details, see “Selecting Multiple Patterns” on page 31.

XTouch in the layout editing screen to delete the selected pattern(s).

■Loading the Mat

While holding the mat level and lightly inserting it into

the feed slot, press in the operation panel.

•For details, see “Loading the Mat” on page 20.

■Cutting

aSelect “Cut” in the draw/cut selection screen.

XThe “Start/Stop” button in the operation panel

lights up.

•Before cutting your project, adjust the blade extension appropriately. For details, see “Adjusting the Blade Extension” on page 18.

Note

•Before continuing operation, make sure that patterns that will be cut out are arranged in the cutting area corresponding to the size of the material to be used.

bAdjust the cutting speed and pressure.

Before cutting the pattern, adjust the cutting speed and pressure. These adjustments can be made from the

settings screen. Press in the operation panel.

XTouch or to change the settings.

2

Note

•Depending on the fabric being used, it may not be cut cleanly if the cutting pressure is not correctly adjusted. For the appropriate cutting pressure, see “Cutting Settings” on page 18.

cPress the “Start/Stop” button to start cutting.

XWhen cutting is finished, the draw/cut selection screen appears again.

■Unloading the Mat

Feed out the mat, and then use the included spatula to peel off the patterns.

For details, see “Unloading the Mat” on page 21.

Tutorial 2 - Cutting Advanced Patterns

In this tutorial, we will cut a built-in pattern in the

category.

27