Brother CM100DM operation manual Cutting, Unloading the Mat

■Cutting

aSelect “Cut” in the draw/cut selection screen.

XThe “Start/Stop” button in the operation panel lights up.

Note

•Make sure that patterns that will be cut out are arranged in the cutting area corresponding to the size of the material attached before continuing operation.

bAdjust the cutting speed and pressure.

Before cutting the pattern, adjust the cutting speed and pressure. These adjustments can be made from the

settings screen. Press in the operation panel and

touch to display the second page of the settings screen.

XTouch or to change the settings and then touch the “OK” key.

Note

•Depending on the fabric being used, it may not be cut cleanly if the cutting pressure is not correctly adjusted. For the appropriate cutting pressure, see “Cutting Settings” on page 18.

cPress the “Start/Stop” button to start cutting.

XWhen cutting is finished, the message “Finished cutting.” appears on the display. Touch the “OK” key to return to the draw/cut selection screen.

■Unloading the Mat

aPress in the operation panel to feed out the mat.

1

bPeel off the material from an area that is easily removable, such as a corner, and then slowly peel while maintaining an even pressure.

cHolding the mat with your hand, use the included spatula to carefully peel off the cut- out patterns.

Note

•For instructions on how to peel off the material, see also “Mat and Cutting Blade Combinations” on page 12.

21