Brother CM100DM BAdjust the pen pressure, CPress the Start/Stop button to start drawing

XThe “Start/Stop” button in the operation panel lights up.

bAdjust the pen pressure.

For details on adjusting the drawing pressure, see step e (page 44) in “Drawing”.

cPress the “Start/Stop” button to start drawing.

XWhen drawing is finished, the message appears in the screen. After you touch the “OK” key, the

draw/cut selection screen appears.

•To perform trial drawing operations to adjust the drawing pressure, repeat steps a through c in this section.

•To cut around the drawn patterns, keep the mat

inserted into the slot without pressing , and continue with the following cutting procedure.

■Cutting

aTouch the “Cut” key.

XA preview of the line to be cut appears.

XThe “Start/Stop” button in the operation panel lights up.

bRemove the pen holder, and then install the blade holder.

Note

•Replace the holder without turning off the machine. If the machine is turned off, the mat will be fed out when it is turned on again. Therefore, the drawn pattern outline and cut pattern may become misaligned, even if the mat is re-inserted.

•After use, remove the pen from the pen holder, and then attach the cap to the pen before storing it.

cPress the “Start/Stop” button to start cutting.

XWhen cutting is finished, the draw/cut selection screen appears.

dPress in the operation panel to feed out the mat.

ePeel the patterns off the mat.

• For details, see “Unloading the Mat” on page 21.

46