Brother CM100DM First Steps, Removing the Transport Packing Materials, Turning On/Off the Machine

FIRST STEPS

The following procedures describe basic operations, from preparing the material to performing trial cutting.

Removing the Transport Packing Materials

Before turning on the machine, remove the shipping tape and the cardboard shock-absorbing material.

Note

•If the packing materials were removed after the machine was turned on, turn the machine off, then on again. Continuing to use the machine without restarting it may result in incorrect operation.

Adjusting the Angle of the Operation Panel

The angle of the operation panel can be adjusted to one of three levels.

To store away the operation panel, first raise it until it is vertical, and then it can be lowered and stored away. If you wish to decrease the angle of the operation panel, raise it until it is vertical, and then adjust the angle again.

Note

•Follow the instructions provided above to lower the panel. Lowering it forcibly may cause damage to the panel.

Turning On/Off the Machine

aConnect the power cord to the AC adapter, and then connect the AC adapter to the machine.

b

a

aPower cord

bAC adapter

Memo

•When using the AC adapter, untie the bundled cord.

bPlug the power cord into an electrical outlet.

10