Brother CM100DM operation manual Editing and Cutting the Second Pattern Piece

■Editing and Cutting the Second Pattern Piece

aSelect and edit the second pattern piece, and then touch the “OK” key.

For details on editing the pattern, follow steps f-h(page 29) in “Selecting and Editing the First Pattern Piece”.

a

aTouch to return to the pattern category selection screen for selecting another pattern.

bFollow the procedures described in “Loading the Mat” (page 20) and “Cutting” (page 21) to load the material to be used for the second pattern piece and cut it out.

XWhen cutting is finished, a message appears.

cAfter all pattern pieces have been cut out, touch the “Finish” key.

XThe draw/cut selection screen appears again.

■Unloading the Mat

Peel from the mat the pattern piece that was cut out. For details on peeling the material from the mat, see “Unloading the Mat” on page 21.

30