Brother CM100DM Installing, CPull up the holder to leave the blade in the rubber area

cPull up the holder to leave the blade in the rubber area.

■Installing

aGrasp the shaft of the new blade, and then insert it into the blade slot in the end of the holder.

The blade shaft is held in place by a magnet in the holder. Slowly insert the blade shaft, and then slowly release it after the shaft snaps into place against the magnet.

bTwist on the holder cap to attach it to the holder.

Fully tighten the cap until the blade extension reaches its maximum, and then loosen the cap until the blade is no longer visible.

a 5

b

aTighten the cap until the blade extension reaches its maximum.

bLoosen the cap until the blade becomes invisible from the cap end.

Note

•Loosen the holder cap until the blade tip is no longer visible. The blade extension scale on the holder applies when the blade begins to be extended from the cap end. For details on the blade extension, see “Adjusting the Blade Extension” on page 18.

57