4. INSTALLATION
--. Installing the transformer
The transformer can be installed on the floor, on the work table leg (on top of the leg or on the treadle support plates) or underneath the work table.
Check the power supply rating label on the transformer to confirm that the voltage ratings for the transformer and the control box are identical.
1) Floor installation
Select a suitable location, and place the transformer on the floor in that location.
* Select a location where the transformer will not be an obstruction to people walking past.
2069Q
2) Table leg installation (on top of table leg)
2070Q
Screw (M5 x 8)
Mounting
bracket
112.5mm2071Q
3) Table leg installation (treadle support plates)
3875Q | 4035Q |
Washer | Screw (M6 x 14) |
|
3876Q
Secure the transformer to the top of the table leg using the mounting bracket and screws.
*The mounting bracket and screws must be obtained separately.
1.Remove the four screws (1), and then remove the two handles (2).
2.Place the transformer on top of the two treadle support plates (3) as shown in the diagram, and then secure it to the handle (2) using the washers and screws.
* The washers and screws must be obtained separately.
17 |