5. OPERATION￿

￿

￿. OPERATION

￿-￿. Name and function of each operation panel item

3902Q

(1)Power indicator

Illuminates when the power is turned on.

(2)Warning indicator

Illuminates when an error occurs, and after the RESET key is pressed to lower the work clamp but the needle is not at the up stop position when the machine pulley turns.

Also, illuminates as a warning when a dangerous situation occurs, such as if the machine is connected to a high-voltage power supply by mistake.

If the warning indicator is illuminated, the sewing machine will not start even if the treadle is depressed.

(3)RESET key

Used to reset errors, and to raise and lower the work clamp.

(4)Cutter on indicator

When this indicator is illuminated, the cutter operates during automatic sewing. When it is switched off, the cutter does not operate during automatic sewing.

(5) CUTTER ON key

This key is used to turn cutter operation during automatic mode, test feed mode, manual mode and program mode on and off. When cutter operation is turned on, the cutter on indicator illuminates.

(6) Program number LED

Displays the program number in automatic mode, test feed mode and manual mode.

Displays the parameter number in program mode.

* The program number changes in the order 1 ￿ 2 ￿ ... ￿ 90 ￿ P1 ￿ ... ￿ P9 ￿ C1 ￿ ... ￿ C9 ￿ C0. ￿ ... C9.

￿ 1. P1 to P9 are programs that are created by the programming software for the electronic pattern sewer, and C1 to C9. are cycle programs.

(7)Program No. UP key

Press to increase the value in the program number LED.

27

HE-800A