10. STANDARD￿ ADJUSTMENTS

￿

￿￿-￿. Adjusting the lower thread clamp timing

Becomes

faster Becomes slower

When reference line A on feed guide shaft B (1) is aligned with the edge of the feed arm support (2), the opening plate (3) will start moving when the feed mechanism moves 6 - 7 mm from the home position, and the lower thread retainer (4) will open.

To change the opening timing, loosen the screw (5) of the feed arm support (2) and move feed guide shaft B

(1) to the left or right.

3988Q

￿￿-￿. Adjusting the bobbin presser

1. Set the sewing machine to the home position and then press the RESET key.

2. Loosen the set screw (1), and then adjust so that the bobbin presser (2) goes into the hole in the bobbin case (3).

3. Check that the work clamp is at the home position, and then loosen the nut (4) and turn the screw (5) to adjust the clearance A between the bobbin presser

(2) and the edge of the bed to approximately 12.5 mm.

3989Q

￿￿-￿￿. Adjusting the needle up stop position

The needle up stop position is adjusted so that the index mark (2) on the machine pulley (1) is inside the mark (4) on the belt cover (3).

If adjustment is necessary, loosen the screw (5) of the machine pulley (1). The machine pulley (1) will stop more slowly if the screw (5) is moved counter to the normal direction of rotation, and will stop more quickly if the screw (5) is moved in the normal direction of rotation.

Note:

The screw (6) at the “D” mark is an adjusting screw for the needle down detection function and is adjusted to match the feed timing, so it should not be loosened.

3990Q * If the index mark (2) is not inside the mark (4) when the sewing machine is started, and error code “E-02”

will be displayed. Turn the machine pulley to move the index mark (2) to the correct position and then start the sewing machine.

77

HE-800A