5. OPERATION | |
|
|
You can use the programming software for electronic pattern sewer to create your own sewing patterns. Up to nine of the patterns which you create in this way can be programmed into a
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before opening the face plate of the control box. Touching areas where high voltages are present can result in severe injury.
3944Q | 3945Q |
|
|
1.Remove the six screws (1), and then open the cover (main P.C. board mounting plate (2)). Note: When opening the cover, hold it securely so that it does not fall down.
2.Remove the
3.Create the pattern(s) using the programming software for electronic pattern sewer. Refer to the Operating Instructions for the programming software for electronic pattern sewer for details on how to create patterns.
4.Add the pattern(s) created to the
5.Install the
6.Close the cover (main P.C. board mounting plate (2)), and tighten the six screws (1).
The program numbers for patterns which have been created using the programming software for electronic pattern sewer range from P1 to P9. However, program numbers which have not yet been assigned to a program will not appear on the program number LED.
1 2 3…… 90 P1 P2…… P9
You can check and change the following parameters for patterns which have been created using the programming software for electronic pattern sewer.
No. | Setting items | Setting range | Unit | Default |
00 | Sewing speed (zigzag part) | 1,000 - 4,000 sti/min | 100 | 3,600 |
02 | Length of knife | Value is for checking purposes | - | - |
|
| and cannot be changed. |
|
|
08 | Knife X position alignment | 0.1 | 0.0 | |
09 | Knife Y position alignment | 0.1 | 0.0 | |
16 | Running speed (Straight bar tack) | 1,000 - 3,000 sti/min | 100 | 2,000 |
48 | Underlay speed | 1,000 - 3,000 sti/min | 100 | 2,000 |
60 | Slow speed | 500 - 1,500 sti/min | 100 | 800 |
61 | Rear tack speed | 500 - 4,000 sti/min | 100 | 4,000 |
62 | Front tack speed | 500 - 4,000 sti/min | 100 | 4,000 |
54 |