10. STANDARD ADJUSTMENTS | |
|
|
After setting the sewing machine to the home position, press the RESET key and then make the adjustment.
4104M | 4105M |
Start touching at 1.5 - 2.5 mm
Start touching at 1.5 – 2.5 mm
Approx. 0.5 mm
Approx. 2 mm
Feed arm
Approx.
1.0 – 1.5 mm
Approx. 0.5 mm
4106M | 3987Q |
1.Loosen the two bolts (3), and then adjust so that the distance (b) between ridge line (B) on the opening cam (1) and the upper thread scissors (2) is 0.5 mm, and so that ridge line (B) on the opening cam is parallel to the feed direction.
2.Loosen the two screws (4), and then adjust so that the distance (c) between the rising section (C) of the upper thread scissors (2) and the tip of the opening cam (1) is approximately 0.5 mm when the upper thread scissors (2) are closed.
* If you would like the scissors to start opening earlier, make the distance smaller. However, if you make the distance smaller, check that the rising section (C) of the upper thread scissors (2) does not touch the opening cam
(1) and prevent the upper thread scissors (2) from opening when the work clamp is lowered.
3.Apply grease to the inclined face (D) of the opening cam (1).
Scissors fully opening timing adjustment1.Loosen the two bolts (7), and then adjust the support plate (8) so that the back plate (5) and the cam (6) overlap by approximately 1.0 – 1.5 mm.
Note: If the amount of overlap is too small, the upper thread scissors will not open properly and the upper thread scissors and the cutter may touch each other.
2.Loosen the two bolts (9), and then adjust the clearance between the bend in the back plate (5) and the cam (6) to approximately 2 mm.
* If you would like the scissors to start opening earlier, make this clearance smaller.
3.Check that the upper thread scissors (2) open smoothly during feeding.
Note: If the upper thread scissors (2) do not open smoothly, the upper thread scissors (2) may touch the cutter and needle breakage may occur.