Manual and automatic fax Redial
If you are sending a fax manually and the line is busy, press Redial/Pause, and then press Start to try again. If you want to make a second call to the last number dialed, you can save time by pressing Redial/Pause and Start.
Redial/Pause only works if you dialed from the control panel.
If you are sending a fax automatically and the line is busy, the MFC will automatically redial one time after five minutes.
Dual Access
You can dial a number, and begin scanning the fax into memory— even when the MFC is receiving, sending or printing a fax from memory. The LCD shows the new job number.
If you get an Out of Memory message while scanning the first page of a fax, press Stop/Exit to cancel scanning. If you get an Out of Memory message while scanning a subsequent page, you can press Start to send the pages scanned so far, or press Stop/Exit to cancel the operation.
1
2
3
If it is not illuminated in green, press 
(Fax). Load the original document.
Enter the fax number. Press Start to send the fax.
The MFC starts scanning the first page and the LCD shows the job number (#XXX) of the fax. You can repeat Steps 1 to 3 for the next fax.
SETUP SEND 6 - 7