BT manual Additionally, if you have purchased the Synergy 3500 Twin, handsets, please see page

Synergy 3500 user guide ~ 3rd Edition ~ 21st October ’02 ~ 4461

If you wish to register additional

handsets, please see page 53.

Please see the table below for your Synergy 3500 default settings.

Synergy 3500 Default Settings Table

Feature	Default Setting
Day/Time Stamp	Sunday 12:01 pm
Answer Delay	Your answering
	machine will answer
	after 6 rings
Audible Message	OFF
Alert Tone
Outgoing Message	Answer and Record
	“Hello your call cannot
	be taken at the
	moment so please
	leave your message
	after the tone.”
Answer Mode	ON
Base ringer level	High
Base loudspeaker	Level 5
volume
PIN code	0000
Dialling mode	Tone

If you wish to personalise your answering machine settings, for example record your own outgoing message etc, please see “Setting up and personalising your answering machine” beginning on page 35.

The answering machine will now be switched ON and set to its default settings so your Synergy 3500 is now ready for use.

Additionally, if you have purchased the Synergy 3500 Twin:

1.Connect the power supply to the charger (item code 003313).

Plug the power adaptor into the mains power socket on the underside of the charger.

Plug the adaptor into the mains power supply and switch on.

Note

The charger must be plugged into the mains power socket at all times.

2.Install the rechargeable batteries in the handset.

3.Charge the handset batteries for at least 16 hours.

Your Synergy 3000 additional handset comes pre-registered to the main base station as SYNERGY HS2. This will be shown on the display.

Your Synergy 3500 Twin

is now ready for use.

SETTING UP

16