Utilization Screen, Environment Screen | Cabletron Systems 9C300-1

9C300-1 Environmental Module Operation

The Utilization Screen

The Utilization Screen, as shown in Figure 3-8,is the second screen of the non-interactive mode.

Line 1 displays the screen heading.

Line 2 displays the FDDI 1 and FDDI 2 bus utilization.

Line 3 displays the INB A and INB B bus utilization.

Line 4 displays the system status.

SYSTEM UTILIZATION

FDDI 1_ _ _ _ _ 100% FDDI 2 _ _ _ _ _100%

INB A _ _ _ _ _100% INB B _ _ _ _ _ 100%

SYSTEM STATUS NORMAL

Figure 3-8. The Utilization Screen

The Environment Screen

The Environment Screen, as shown in Figure 3-9,is the third screen of the non-interactive mode.

Line 1 displays the screen heading.

Line 2 displays the external temperature of the chassis in both Fahrenheit and Celsius and qualiﬁes the temperature as COLD, COOL, NORM (normal), WARM or HOT based on system parameters.

Line 3 displays the non-condensing humidity level of the chassis and qualiﬁes it as STATIC RISK, NORM (normal) or MOIST based on system parameters.

Line 4 displays the system status.

CHASSIS ENVIRONMENT

EXTERNAL TEMP xxx˚F xx˚C NORM

HUMIDITY xxx% NORM

SYSTEM STATUS NORMAL

Figure 3-9. The Environment Screen

3-10

Image 22

Cabletron Systems 9C300-1 manual Utilization Screen, Environment Screen

Contents

MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page FCC Notice DOC Notice Contents Chapter Speciﬁcations Appendix B Uninterruptible Power Supply UPSAppendix a Epim Speciﬁcations Using This Manual 9C300-1 Environmental Module System Cooling FeaturesOut-of-Band Management Flash Eeprom Environmental/Power MonitoringRelated Manuals Hot Swapping Getting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module 9C300-1 Environmental Module Operation Monitoring Functions External Ambient Temperature Temperature Range LCD Display Fan Speed 9C300-1 Environmental Module and Fan Tray System Voltages Internal Operating TemperatureSystem Humidity Humidity LCD Display Lanview LEDs LED Color State Description Out-of-Band Management COM1 and COM2 Ports Pin Description Ethernet Port Interface Module Epim LCD and Keypad Non-Interactive Mode Screens Non-Interactive ModeSystem Screen Utilization Screen Environment Screen Power Screen System Banner Screen Interactive Mode Interactive Mode Screens Alarm Screen Main Screen ENV Supplies Installed 2 PWR Redundancy Status 1 on 2 on Exit Power Supply Speciﬁc Screen Communications Screen Diagnostic Module Selection Screen Diagnostic Results Screen BBU Screen Module Selection Screen Fault Module Speciﬁc Screen Module Environment Screen Module Memory Screen Module Backplane Screen Environmental Module Speciﬁc Screen Environmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Safety Service Physical DimensionsWeight Environmental Epim Speciﬁcations Introduction EPIM-F1 and EPIM-F2 Parameter Typical Value Worst Worst Case Budget EPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Connector Type Grounding EPIM-A and EPIM-X AUI Port Pin Number Represents Epim Speciﬁcations Uninterruptible Power Supply UPS Connecting a UPS to an EM Uninterruptible Power Supply UPS Conﬁguring COM Port for UPS Verifying Conﬁguration Monitoring UPS Uninterruptible Power Supply UPS