Cabletron Systems 9C300-1 specs

Notice

Notice

Cabletron Systems reserves the right to make changes in speciﬁcations and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, ﬁrmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

© Copyright November 1994 by:

Cabletron Systems, Inc.

35 Industrial Way

Rochester, NH 03867-0505

All Rights Reserved

Printed in the United States of America

Order Number: 9031155 November 1994

LANVIEW is a registered trademark and MMAC-Plusis a trademark of Cabletron Systems, Inc.

VT100 is a registered trademark of Digital Equipment Corporation.

Ethernet is a trademark of Xerox Corporation.

CompuServe is a registered trademark of CompuServe, Incorporated.

i

Image 3

Cabletron Systems 9C300-1 manual

Contents

MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page DOC Notice FCC Notice Contents Appendix B Uninterruptible Power Supply UPS Chapter SpeciﬁcationsAppendix a Epim Speciﬁcations 9C300-1 Environmental Module Using This Manual Features System CoolingOut-of-Band Management Hot Swapping Environmental/Power MonitoringRelated Manuals Flash Eeprom Getting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Monitoring Functions 9C300-1 Environmental Module Operation Temperature Range LCD Display External Ambient Temperature 9C300-1 Environmental Module and Fan Tray Fan Speed Humidity LCD Display Internal Operating TemperatureSystem Humidity System Voltages LED Color State Description Lanview LEDs Out-of-Band Management Pin Description COM1 and COM2 Ports LCD and Keypad Ethernet Port Interface Module Epim Non-Interactive Mode Non-Interactive Mode ScreensSystem Screen Environment Screen Utilization Screen System Banner Screen Power Screen Interactive Mode Screens Interactive Mode Main Screen Alarm Screen ENV Power Supply Speciﬁc Screen Supplies Installed 2 PWR Redundancy Status 1 on 2 on Exit Communications Screen Diagnostic Results Screen Diagnostic Module Selection Screen Module Selection Screen BBU Screen Module Speciﬁc Screen Fault Module Memory Screen Module Environment Screen Environmental Module Speciﬁc Screen Module Backplane Screen Environmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Service Safety Environmental DimensionsWeight Physical Introduction Epim Speciﬁcations Parameter Typical Value Worst Worst Case Budget EPIM-F1 and EPIM-F2 EPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Grounding Connector Type Pin Number Represents EPIM-A and EPIM-X AUI Port Epim Speciﬁcations Connecting a UPS to an EM Uninterruptible Power Supply UPS Conﬁguring COM Port for UPS Uninterruptible Power Supply UPS Monitoring UPS Verifying Conﬁguration Uninterruptible Power Supply UPS