Cabletron Systems 9C300-1 manual Module Specific Screen, Fault

Interactive Mode

The Module Specific Screen

Select a module on the Module Selection Screen, as shown in Figure 3-23,to display configuration information on the Module Specific Screen, as shown in Figure 3-24.

Line 1 identifies the selected module by chassis slot location, current status, and hardware revision. A module’s status can be one of the following:

ON-LINE	The host processor is operational.
DOWN	The host processor is not operational.
FAULT	The power-up diagnostic tests have failed.

Lines 2 and 3 display a firmware revision and SMB-1 firmware revision, along with the BOOT PROM revision and the module serial number.

Line 4 lists the following three submenus. Access a specific submenu by selecting it on the screen.

<ENV>	accesses the Module Environment Screen, showing
	environmental parameters for the selected module.
<MEMORY>	accesses the Module Memory Screen, showing the amount of
	various memory categories on the module.
<BACKPLANE>	accesses the Module Backplane Screen, showing backplane
	configuration parameters.

MODULE xx STATUS ON-LINE HW REV xxx

FW REV x.xx.xx SMB 1 FW REV x.xx.xx

BOOT PROM REV x.xx.xx SN xxxxxxxxxxxx

<ENV> <MEMORY> <BACKPLANE> <EXIT>

Figure 3-24. The Module Specific Screen

Select <EXIT> to return to the Module Selection Screen.

3-19