Cabletron Systems 9C300-1 manual Configuring COM Port for UPS, Uninterruptible Power Supply UPS

Uninterruptible Power Supply (UPS)

	MMAC							EPIM
								STATUS	COM 1	COM 2
								ALARM
						9C3001
1	2	3	4	5	6	7	8	9	1 0	1	1 2	1 3	1 4

MMAC-Plus Chassis (Front View)

9 Pin D Connector Receptacle

Matrix UPS (Back View)

COM Ports

Figure B-1. Connecting EM to UPS

Configuring COM Port for UPS

After the UPS has been connected to the COM2 port, the COM2 port must be configured for UPS Management. To configure the COM2 port for UPS Management, follow the steps below.

1.Connect the terminal or PC used for local management to the COM1 port on the Environmental Module (EM) and press RETURN until the Slot Selection Screen displays.

2.At the Slot Selection Screen, enter 0 (zero) to display the EM Configuration Screen.

3.At the EM Configuration Screen, cursor to the Application Field for the COM2 port.

4.Using the space bar, toggle to the UPS option.

5.Using the tab key, tab to the SAVE option and press RETURN.

If you need additional information about configuring the COM ports, refer to the Local Management User’s Guide.

B-2