EPIM-F1 and EPIM-F2 | Cabletron Systems 9C300-1 instruction

EPIM-F1 and EPIM-F2

Table A-2. Transmitter Power

	Parameter	Typical Value	Worst	Worst Case	Typical
	Parameter	Typical Value	Case	Budget	Budget
			Case	Budget	Budget


	50/125 ∝m	-13.0 dBm	-15.0 dBm	13.0 dB	17.5 dB
	ﬁber

	62.5/125 ∝m	-10.0 dBm	-12.0 dBm	16.0 dB	20.5 dB
	ﬁber

	100/140 ∝m	-7.0 dBm	-9.0 dBm	19.0 dB	23.5 dB
	ﬁber

	Error Rate	Better than 10-10

NOTE

The transmitter power levels and receive sensitivity levels listed are Peak Power Levels after optical overshoot. A Peak Power Meter must be used to correctly compare the values given above to those measured on any particular port. If Power Levels are being measured with an Average Power Meter, then 3 dBm must be added to the measurement to correctly compare those measured values to the values listed (i.e., -30.5 dBm peak = -33.5 dBm average).

A-3

Image 41

Cabletron Systems 9C300-1 manual EPIM-F1 and EPIM-F2

Contents

MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page DOC Notice FCC Notice Contents Appendix a Epim Speciﬁcations Appendix B Uninterruptible Power Supply UPSChapter Speciﬁcations 9C300-1 Environmental Module Using This Manual Out-of-Band Management FeaturesSystem Cooling Related Manuals Environmental/Power MonitoringFlash Eeprom Hot Swapping Getting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Monitoring Functions 9C300-1 Environmental Module Operation Temperature Range LCD Display External Ambient Temperature 9C300-1 Environmental Module and Fan Tray Fan Speed System Humidity Internal Operating TemperatureSystem Voltages Humidity LCD Display LED Color State Description Lanview LEDs Out-of-Band Management Pin Description COM1 and COM2 Ports LCD and Keypad Ethernet Port Interface Module Epim System Screen Non-Interactive ModeNon-Interactive Mode Screens Environment Screen Utilization Screen System Banner Screen Power Screen Interactive Mode Screens Interactive Mode Main Screen Alarm Screen ENV Power Supply Speciﬁc Screen Supplies Installed 2 PWR Redundancy Status 1 on 2 on Exit Communications Screen Diagnostic Results Screen Diagnostic Module Selection Screen Module Selection Screen BBU Screen Module Speciﬁc Screen Fault Module Memory Screen Module Environment Screen Environmental Module Speciﬁc Screen Module Backplane Screen Environmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Service Safety Weight DimensionsPhysical Environmental Introduction Epim Speciﬁcations Parameter Typical Value Worst Worst Case Budget EPIM-F1 and EPIM-F2 EPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Grounding Connector Type Pin Number Represents EPIM-A and EPIM-X AUI Port Epim Speciﬁcations Connecting a UPS to an EM Uninterruptible Power Supply UPS Conﬁguring COM Port for UPS Uninterruptible Power Supply UPS Monitoring UPS Verifying Conﬁguration Uninterruptible Power Supply UPS