Non-Interactive Mode, System Screen | Cabletron Systems 9C300-1

Non-Interactive Mode

Non-Interactive Mode

The LCD defaults to this mode if there is no user input within 60 seconds of installation of the Environmental Module or system start-up.

Non-Interactive Mode Screens

This section describes the LCD screens that display in the non-interactive mode. The LCD scrolls through different status screens (depending on MMAC-Plus conﬁguration), displaying each screen for a period of 7 seconds; or, until user input is sensed on the keypad.

Line 4 of each screen displays any active alarm conditions that exist within the system. If no alarm conditions exist, the line displays “SYSTEM STATUS NORMAL.”

If an alarm condition exists, line 4 displays a message describing the alarm for 5 seconds. The screen then displays a message stating how many alarms are present in the alarm queue, “XX ALARMS PENDING” and the ALARM LED on the front of the Environmental Module turns yellow or red indicating unread alarms in the queue.

The System Screen

The System Screen, as shown in Figure 3-7,is the ﬁrst screen of the non-interactive mode.

Lines 1 and 2 display the MMAC-Plus chassis Internet Protocol (IP) address and Media Access Control (MAC) address.

Line 3 displays the current chassis hardware revision and serial number.

Line 4 displays the system status.

CHASSIS IP ADDRESS xxx.xxx.xxx.xxx

CHASSIS MAC ADDRESS xx-xx-xx-xx-xx-xx

CHASSIS HW REV xxx SN xxxxxxxxxxxx

SYSTEM STATUS NORMAL

Figure 3-7. The System Screen

3-9

Image 21

Cabletron Systems 9C300-1 manual Non-Interactive Mode Screens, System Screen

Contents

MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page DOC Notice FCC Notice Contents Appendix B Uninterruptible Power Supply UPS Chapter SpeciﬁcationsAppendix a Epim Speciﬁcations 9C300-1 Environmental Module Using This Manual Features System CoolingOut-of-Band Management Related Manuals Environmental/Power MonitoringFlash Eeprom Hot Swapping Getting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Monitoring Functions 9C300-1 Environmental Module Operation Temperature Range LCD Display External Ambient Temperature 9C300-1 Environmental Module and Fan Tray Fan Speed System Humidity Internal Operating TemperatureSystem Voltages Humidity LCD Display LED Color State Description Lanview LEDs Out-of-Band Management Pin Description COM1 and COM2 Ports LCD and Keypad Ethernet Port Interface Module Epim Non-Interactive Mode Non-Interactive Mode ScreensSystem Screen Environment Screen Utilization Screen System Banner Screen Power Screen Interactive Mode Screens Interactive Mode Main Screen Alarm Screen ENV Power Supply Speciﬁc Screen Supplies Installed 2 PWR Redundancy Status 1 on 2 on Exit Communications Screen Diagnostic Results Screen Diagnostic Module Selection Screen Module Selection Screen BBU Screen Module Speciﬁc Screen Fault Module Memory Screen Module Environment Screen Environmental Module Speciﬁc Screen Module Backplane Screen Environmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Service Safety Weight DimensionsPhysical Environmental Introduction Epim Speciﬁcations Parameter Typical Value Worst Worst Case Budget EPIM-F1 and EPIM-F2 EPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Grounding Connector Type Pin Number Represents EPIM-A and EPIM-X AUI Port Epim Speciﬁcations Connecting a UPS to an EM Uninterruptible Power Supply UPS Conﬁguring COM Port for UPS Uninterruptible Power Supply UPS Monitoring UPS Verifying Conﬁguration Uninterruptible Power Supply UPS