Canon VC-C50IR, VC-C50i Selecting the Camera to be Controlled, Press the i button

ID Mode

Selecting the Camera to be Controlled

<Example> As shown in the figure below, of 4 cameras (ID1 to ID3) only the cameras with ID number 2 (2 cameras) are selected for ID mode operation. In normal operation, the camera LEDs turn green.

ID1ID2ID2ID3

Green Green Green Green

● Check the LEDs on all the adjacent connected cameras to ensure that all the

cameras are receiving the signals from the wireless controller.

NOTE ● The cameras (ID: 0) that have not been assigned on ID number are switched on in step 2.

●Even if the cameras are switched off, when you press the i button the LEDs on all the cameras blink orange and you can begin ID mode operation. However, when a number button was pressed in step 2, the cameras with ID numbers that do not match are switched off.

BRIGHTZOOM

T

W

HOME

SET/OKCANCEL

AF 1 2 3

MF	4	5	6
∞	7	8	9
		0
ON SCREEN Fn		ID	MENU

1.Press the i button.

The LEDs on all the adjacent connected cameras blink orange (at 0.5-second intervals).

ID1 ID2 ID2 ID3

Blinking orange Blinking orange Blinking orange Blinking orange

To cancel ID mode operation, press the c or i button. The LEDs on all the cameras then turn green.

2.Press a number button (in this case 2).

The cameras with ID2 are selected and the LEDs on only those cameras turn green. The LEDs on the other cameras turn orange (not blinking).

ID1 ID2 ID2 ID3

Orange Green Green Orange

This completes the selection procedure. When you use the wireless controller, only the selected cameras will respond. When you press a button on the wireless controller, the LEDs on the selected cameras blink green (at 0.1-second intervals) and the LEDs on the other cameras blink orange (at 0.1-second intervals).

36