Carrier 33CSPREMLK specifications Contents, Safety Considerations Safety Note, General

PremierLink™

Retrofit Split System

Controller

Installation, Start-Up and

Configuration Instructions

Part Number 33CSPREMLK

CONTENTS

Page

SAFETY CONSIDERATIONS . . . . . . . . . . . . . . . . . . . . . . 1

GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1,2

INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-26

Inspection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

PremierLink Controller Hardware. . . . . . . . . . . . . . . . . 2

Field-Supplied Hardware . . . . . . . . . . . . . . . . . . . . . . . . . 2

•SPACE TEMPERATURE (SPT) SENSOR

•SUPPLY AIR TEMPERATURE (SAT) SENSOR

•INDOOR AIR QUALITY CO2 SENSOR

•OUTDOOR AIR QUALITY CO2 SENSOR

•OUTDOOR AIR TEMPERATURE SENSOR

•OUTDOOR AIR ENTHALPY SWITCH

•RETURN AIR ENTHALPY SENSOR

Mount PremierLink Control. . . . . . . . . . . . . . . . . . . . . . . 2

•LOCATION

•MOUNTING

PremierLink Controller Inputs and Outputs . . . . . . 3

Control Wiring. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Install Sensors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

•SPACE TEMPERATURE (SPT) SENSOR INSTALLATION

•SUPPLY AIR TEMPERATURE (SAT) SENSOR INSTALLATION

•INDOOR AIR QUALITY CO2 SENSOR INSTALLATION

•OUTDOOR AIR QUALITY CO2 SENSOR INSTALLATION

•OUTDOOR AIR TEMPERATURE SENSOR

Connect to CCN Communication Bus . . . . . . . . . . . 18

• COMMUNICATIONS BUS WIRE SPECIFICATIONS

Enthalpy and Differential Enthalpy Control . . . . . . 18

•ENTHALPY SWITCH/RECEIVER

•OUTDOOR AND RETURN AIR ENTHALPY SENSOR

Economizer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21

•Q769B

•Q769C

Economizer with Johnson 4 to 20 mA

Actuator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24

•DRIVE DIRECTION

•SWITCH SELECTION

•WIRING

START-UP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26-28

Perform System Check-Out . . . . . . . . . . . . . . . . . . . . . 26

Initial Operation and Test. . . . . . . . . . . . . . . . . . . . . . . . 26

Install Navigator™ Display Module . . . . . . . . . . . . . 26

Password Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28

Forcing Values and Configuring Items . . . . . . . . . . 28

Page

CONFIGURATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28-42

Points Display Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . 28

Thermostat Control Input Screen. . . . . . . . . . . . . . . . 30

Alarm Service Configuration Screen . . . . . . . . . . . . 30

Controller Identification Screen . . . . . . . . . . . . . . . . . 31

Holiday Configuration Screen . . . . . . . . . . . . . . . . . . . 31

Occupancy Configuration Screen . . . . . . . . . . . . . . . 32

Set Point Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32

Service Configuration Selection Screen. . . . . . . . . 33

PremierLink Configuration Screen . . . . . . . . . . . . . . 37

Occupancy Maintenance Screen . . . . . . . . . . . . . . . . 39

Maintenance Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40

SAFETY CONSIDERATIONS

SAFETY NOTE

Air-handling equipment will provide safe and reliable service when operated within design specifications. The equipment should be operated and serviced only by authorized person- nel who have a thorough knowledge of system operation, safety devices and emergency procedures.

Good judgement should be used in applying any manufac- turer’s instructions to avoid injury to personnel or damage to equipment and property.

Disconnect all power to the unit before performing mainte- nance or service. Unit may automatically start if power is not disconnected. Electrical shock and personal injury could result.

Damage to equipment may result. An individual field- supplied 24-vac power transformer is required for each PremierLink controller. The transformer must be less than 100 va to meet UL (Underwriters’ Laboratories) Class 2.

GENERAL

The PremierLink Controller is a field retrofit split system control compatible with the Carrier Comfort Network (CCN). This control is designed to allow users the access and ability to change factory-defined settings thus expanding the function of the standard unit control board. The complete PremierLink package (part number 33CSPREMLK) consists of a control circuit board with plastic cover and label, wire harnesses, spade connectors, wire nuts and 4 mounting screws.

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

Book	1	4	PC 111	Catalog No. 533-80072	Printed in U.S.A.	Form 38-54SI	Pg 1	11-02	Replaces: 38-52SI
Tab	3a	2a