Cisco Systems 2600 manual Configuring Serial Connections, Serial DTE or DCE Devices

Chapter 2 Preparing to Install the Router

Preparing to Connect to a Network

Note To ensure agency compliance with FCC Class B electromagnetic emissions requirements (EMI), make sure that you use a shielded RJ-45 Token Ring cable when connecting your router to a Token Ring network.

Token Ring can operate at two different ring speeds: 4 and 16 Mbps. All devices on the Token Ring must use the same operating speed.

Use a Token Ring cable to connect the router to a switch. Refer to the section “Token Ring Port Pinouts” in the Cisco Modular Access Router Cable Specifications online document for the Token Ring port pinouts. This document is available online and on the Cisco Documentation CD-ROM.

Serial Connections

Serial connections are provided by WAN interface cards and network modules. The WAN interface cards can be installed in either slot of the 2-slot chassis; the network module can be installed in the Cisco 2600 series single network module slot. For more information on WAN interface cards, refer to the Cisco Interface Cards Hardware Installation Guide. For more information on network modules, refer to the Cisco Network Modules Hardware Installation Guide. These documents are accessible online and on the Cisco Documentation CD-ROM.

•For information about installing WAN interface cards, refer to the Cisco Interface Cards Hardware Installation Guide.

•For information about installing network modules, refer to the Cisco Network Modules Hardware Installation Guide.

Before you connect a device to a serial port, you need to know the following:

•Type of device, data terminal equipment (DTE) or data communications equipment (DCE), you are connecting to the synchronous serial interface

•Type of connector, male or female, required to connect to the device

•Signaling standard required by the device

Configuring Serial Connections

The serial ports on the asynchronous/synchronous serial network modules and the serial WAN interface card use DB-60 connectors. Serial ports can be configured as DTE or DCE, depending on the serial cable used.

Serial DTE or DCE Devices

A device that communicates over a synchronous serial interface is either a DTE or DCE device. A DCE device provides a clock signal that paces the communications between the device and the router. A DTE device does not provide a clock signal. DTE devices usually connect to DCE devices. The documentation that accompanied the device should indicate whether it is a DTE or DCE device. (Some devices have a jumper to select either DTE or DCE mode.) If you cannot determine the device type in the documentation, see Table 2-3to help you select the proper device type.

Cisco 2600 Series Routers Hardware Installation Guide

2-10 OL-2171-06