
Chapter 3 Installing the Router
Power Connections
Figure 3-21 Ground Connection Using Ring Terminal, Cisco 2691
ASYNC
ASYNC
ASYNC
ASYNC
ASYNC
EN
Ring terminal
attachment
TD | RD | LP | AL |
| CD |
| SEE |
|
|
| |
|
|
|
|
| |
| MANUAL BEFORE | INSTALLATION | DSU | ||
|
|
|
| 56K | |
ACT |
|
|
|
|
|
100 Mbps |
|
|
|
|
|
LINK |
|
| ACT | CF1 | |
FAST | ETHERNET 0/1 |
| 100 | Mbps |
|
| FAST | LINK |
| ||
|
|
| ETHERNET 0/0 |
|
|
TD | RD | LP | AL |
| SEE |
| CD |
|
|
| |
| MANUAL BEFORE | ||
|
|
| INSTALLATION |
DSU 56K
SEE MANUAL BEFORE INSTALLATION
CISCO2691 ![]()
CONSOLE AUX
103008
After the router has been installed and properly grounded, you can connect the power wiring; the WAN, LAN, and voice cables; and the cables for administrative access, as required for your installation. For cable connection procedures, see the “Power Connections” section on page
Power Connections
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Warning Do not work on the system, or connect or disconnect cables during periods of lightning activity. Statement 1001
Note The installation must comply with all required electrical codes applicable at the installation site.
This section explains how to connect AC or DC power to Cisco 2600 series routers. It covers the following topics:
•Connecting Routers to AC Power, page
•Connecting Routers to a
•Connecting Routers to the Cisco Redundant Power System, page
Connecting Routers to AC Power
If your router uses AC power, connect it to a 15 A, 120 VAC (10 A, 240 VAC) circuit with overcurrent protection.
Note The input voltage tolerance limits for AC power are 85 and 264 VAC.
Cisco 2600 Series Routers Hardware Installation Guide
|
| ||
|
|