Cisco Systems 6500 manual Webvpn gateway

Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module

webvpn gateway

webvpn gateway

To enter the gateway submode and define the virtual gateway, use the webvpn gateway command. Use the no form of this command to remove any commands that you have entered in the WebVPN subcommand mode from the configuration.

webvpn gateway gateway-name

Syntax Description	gateway-name	Name of the virtual gateway service.
Defaults	This command has no default settings.

Command Modes

Command History

Global configuration

Release	Modification
WebVPN Module	Support for this command was introduced on the Catalyst 6500 series
Release 1.1	switches.

Usage Guidelines The gateway-nameargument is case-sensitive.

After you enter the webvpn gateway command, the prompt changes to the following:

webvpn(config-webvpn-gateway)#

After you enter the gateway submode, there are commands available to configure the virtual gateway services. Table 2-9lists the virtual gateway submode commands.

Table 2-9 Virtual Gateway Submode Commands

Command	Purpose and Guidelines	Defaults
exit	Exits from the gateway configuration mode and returns to
	the global configuration mode.
hostname hostname	Specifies the name of the gateway that is used in the URL
	and cookie mangling process. In the load-balancing
	configuration, the hostname specified here is the virtual
	gateway IP address configured on the LB device.
http-redirect [port port]	Specifies that the HTTP port is open and that any HTTP	port is 80.
	connections to the virtual gateway is directed to use secure
	HTTP (HTTPS).
	port port—(Optional) Specifies the port number to be
	redirected; valid values are from 1 to 65535.
inservice	Enables the WebVPN gateway. Use the no form of this
no inservice	command to disable the WebVPN gateway.
	Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1
OL-7310-01			2-101