Cisco Systems ATA 188 Tone Configuration Parameters, Tone Parameter Syntax-Basic Format, page

Chapter 5 Parameters and Defaults

Tone Configuration Parameters

TOS

Description

This parameter allows you to configure Type of Service (ToS) bits by specifying the precedence and delay of audio and signaling IP packets, as follows:

•Bits 0-7—These bits are for the ToS value for voice data packets.

–Range: 0-255

–Default: 184

•Bits 8-15—These bits are for the ToS value for signaling-data packets

–Range: 0-255

–Default: 168

•Bits 16-31—Reserved.

Value Type

Bitmap

Default

0x000068B8

Voice Configuration Menu Access Code

255

Note This parameter is called UDPTOS in previous Cisco ATA releases. If you are performing a Cisco ATA upgrade, the previous value of the UDPTOS parameter is carried forward to the TOS parameter.

Tone Configuration Parameters

The Cisco ATA supports the following tone parameters:

•DialTone

•BusyTone

•ReorderTone

•RingBackTone

•CallWaitTone

•AlertTone

The Cisco ATA supports two types of tone-parameter syntax—basic format and extended format. Basic format is used in most countries; use the extended format only if the country in which the Cisco ATA is used requires this format.

This section covers all the call-progress tones that the Cisco ATA supports, and contains the following topics:

•Tone Parameter Syntax—Basic Format, page 5-30

•Tone Parameter Syntax—Extended Formats, page 5-31

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)

OL-4803-01 5-29