Cisco Systems ATA 188 manual 5-25, Bit Number, 2 ConnectMode Parameter Bit Definitions continued

Chapter 5 Parameters and Defaults

Operational Parameters

Table 5-2 ConnectMode Parameter Bit Definitions (continued)

Bit Number Definition

130—Use G.711µ-law for fax pass-through codec. 1—Use G.711A-law for fax pass-through codec.

	Default: 0
14-15	0—Use fax pass-through.
	1—Use codec negotiation in sending fax.
	2,3—Reserved.
	Default: 0

160—Use non-NCS-compliant Session Description Protocol (SDP). 1—Use NCS-compliant SDP.

Default: 0

170/1—Disable/enable automatic MGCP-version detection. Default: 0

180/1—Enable/disable persistent on-hook and off-hook events. Default: 0

190/1—Enable/disable persistent hook-flash events. Default: 0

200/1—Disable/enable using a pair of brackets to enclose the IP address of an endpoint identifier. For more information, see the “Endpoints and Connections” section on page 4-3.

Default: 0

210—Enables G.729 codec on the Phone 1 port. 1—Enables G.729 codec on the Phone 2 port. Default: 0

220—Use loop mode for quarantine handling. 1—Use step mode for quarantine handling. Default: 0

230/1—Disable/enable conference connection mode. Default: 0

240/1—Enable/disable support for RSIP*@ipaddress syntax. For more information, see the “Cisco ATA Registration Process with MGCP” section on page 4-4.

	Default: 0
25-31	Reserved.

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)

OL-4803-01 5-25