Cisco Systems ATA 188 manual Preliminary Steps, Running the Executable File, Upgrade Requirements

Chapter 7 Upgrading the Cisco ATA Signaling Image

Upgrading the Signaling Image Manually

Preliminary Steps

Before you run the executable file, be sure to complete the following procedure:

Procedure

Step 1 If you are a registered CCO user. go to the following URL:

http://www.cisco.com/cgi-bin/tablebuild.pl/ata186

Step 2 Locate the zip file that contains the software for the applicable release and signaling image you are using. The contents of each file are described next to the file name. Extract the signaling image file (this file has an extension of .zup—For example, ata186-v2-15-020723a.zup) and store it on the PC that has connectivity with the Cisco ATA.

Step 3 Set the Cisco ATA parameter UseTftp to 0.

Note Remember to set this parameter back to 1 before you use the TFTP upgrade method at a later time.

Step 4 Follow the instructions in the “Running the Executable File” section on page 7-3.

Running the Executable File

This section includes the procedure for running the executable file and using the voice configuration menu to complete the upgrade process. First check to make sure the upgrade requirements are met and determine the syntax to use when running the program.

This section contains the following topics:

•“Upgrade Requirements” section on page 7-3

•“Syntax” section on page 7-3

•“Upgrade Procedure” section on page 7-4

Upgrade Requirements

The following list contains the requirements for using the ata186us.exe file and the voice configuration menu to upgrade the Cisco ATA to the latest signaling image:

•A network connection between the PC from which you will invoke the executable file and the Cisco ATA

•A PC running Microsoft Windows 9X/ME/NT/2000

Syntax

ata186us [-any]{-h[host_ip]} {-p[port]} {-quiet} [-d1 -d2 -d3] <image file>

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)

OL-4803-01 7-3