Cisco Systems C892FSPK9 Warnings, Installing Antennas

2-4

Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide

OL-16215-11

Chapter 2 Installing the Router

Installing the Router

Warnings

Warning

This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect

the host to earth ground during normal use.

Statement 242

Warning

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the

absence of a suitably installed ground conductor. Contact the appropriate electrical inspection

authority or an electrician if you are uncertain that suitable grounding is available.

Statement 1024

Warning

Read the wall-mounting instructions carefully before beginning installation. Failure to use the

correct hardware or to follow the correct procedures could result in a hazardous situation to people

and damage to the system.

Statement 378

Note • Do not stack anything on top of the router.

•Do not cover or obstruct the router vents located on both sides and top of the routers; otherwise,

overheating could occur and cause damage to the router.

•Place router in ventilated area to avoid local air heating.

Caution Do not cover or obstruct the router vents located on both sides of the router; otherwise, overheating could

occur and cause damage to the router.

Caution Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not

stack routers on a desktop. Excessive weight on top of the router could damage the chassis.

Caution Do not install the router or power supplies next to a heat source of any kind, including heating vents.

Caution The top surface of the router is hot since heat is dissipated through the top. Do not keep any object in

direct contact with the surface for a prolonged period.

The Cisco 890 series wireless routers have three reverse-polarity threaded Neill-Concelman (RP-TNC)

connectors on the back panel. The antennas that are shipped with the router are dual-band 2.4-GHz to

5-GHz omnidirectional dipole antennas.