Chapter 3 Connecting the Router

Connecting Power over Ethernet

Caution The primary WAN port is designed for an RJ-45 connector only. Damage to the primary WAN port may occur if a non-RJ-45 connector is inserted

Note The DSL line must be provisioned by your service provider and correctly configured so that the LED shows the carrier detect (CD) status. On Cisco 860VAE routers, check the DSL Link LED.

Connecting Power over Ethernet

Warning This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. Statement 1028

Warning This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source or an IEC60950 compliant limited power source. Statement 353

Figure 3-24shows how to connect the 48-VDC Power over Ethernet (PoE) power adapter to your router. The PoE adapter provides power to ports 0 and 1 of the 4-port 10/100 FE switch on the Cisco 880 series routers and ports 0,1, 2, and 3 of the 8-port 10/100 FE switch on the Cisco 890 series routers.

Note The router must also be connected to an AC power outlet through a 12-VDC adapter. To connect the router to an AC outlet, see the“Connecting the AC Adapter” section on page 3-28.

Note Be sure that the internal PoE is enabled for this connection procedure to work.

 

 

Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide

 

 

 

 

 

 

OL-16215-11

 

 

3-27

 

 

 

 

 

Page 111
Image 111
Cisco Systems C892FSPK9 manual Connecting Power over Ethernet