Cisco Systems C892FSPK9 manual To DSL line, On when DSL WAN mode is selected and DSL training

Chapter 3 Connecting the Router

Verifying Connections

Table 3-3	Verifying the Router Operation (continued)
Power and Link		LEDs to Check	Normal Patterns
To DSL line		DSL LINK	On when DSL WAN mode is selected and DSL training
(860VAE models			complete.
only)			Blinking when DSL WAN mode is selected but incomplete
			DSL LinkUp state such as in-training (slow initially, fast
			when almost connected), or controller "OFF", or no cable
			attached to DSL connector.
			Off when the device is powered off; or GE WAN mode is
			selected.
		DSL ACT	On when the DSL interface is up.
			Blinking when there is DSL WAN activity (traffic in either
			direction).
			Faster blinking when there is heavier traffic.
			Off when the device is powered off or the DSL WAN
			interface is down.
To WAN GE line		GE Mode	On when GE WAN mode is selected.
(860VAE models			Off when the device is powered off or when DSL WAN
only)
			mode is selected.
		GE ACT	On when the GE WAN interface is up.
			Blinking when there is GE WAN activity (traffic in either
			direction).
			Off when the device is powered off or when the GE WAN
			interface is down.

1.FE = Fast Ethernet.

2.xDSL = General term referring to various forms of DSL, including ADSL (asymmetric digital subscriber line), VDSL (very-high-data-rate digital subscriber line), and G.SHDSL.

3.DSLAM = digital subscriber line access multiplexer.

4.3G = Third-Generation.

5.WWAN = wireless WAN.

6.RSSI = Received Signal Strength Indicator.

7.CDMA = code division multiple access.

8.GSM = Global System for Mobile Communications.

9.PPP = Point-to-Point Protocol.

10.PPPoE = PPP over Ethernet.

11.PPPoA = PPP over ATM.

12.VPN = Virtual Private Network.

13.SSID = service set identifier.

14.PoE = Power over Ethernet.

15.SFP = small-form-factor pluggable.

	Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
3-42	OL-16215-11