Intermate 100 manual Intermate1xx, Value Where the output is sent by the print server

Services in “Input Control”: ThinPrint

	to use an extensions describing a printer ID, for example:
	192.168.51.100:2#HP3Si
	The ThinPrint server sends the value between the colon and
	the # mark to the Intermate1xx. Provided that this is one of the
	values listed on the table below, it will override the settings
	“Output to” on the [ThinPrint] configuration page in the
	Intermate1xx.
Value	Where the output is sent by the print server
1	Local parallel printer port (the printer on which the Intermate1xx is attached). This printer
	skips the logical layer, so there are no possibilities for pre- or post-processing, string
	substitution, or functioning in a printer pool with load balancing.

1x Two-digit values starting with the digit 1 allow the user to choose a network printer without having to go through the logical printer layer. These values only work on G32. Used on G22, they will cause the print job to be directed to the local printer. A message will be written to the SystemLog.

11	Network Destination 1
12	Network Destination 2
13	Network Destination 3
14	Network Destination 4
2x Two-digit values starting with the digit 2 allow the user to choose a logical printer (1-8, inclusive).
21	Logical Printer 1
22	Logical Printer 2
23	Logical Printer 3
24	Logical Printer 4
25	Logical Printer 5
26	Logical Printer 6
27	Logical Printer 7
28	Logical Printer 8
all other	The setting on the [ThinPrint] configuration page will be used.
values	Note that the only way to direct a job to Logical Printer 0, and thus to the System Target
	Printer configured in Basic > [General], is to set “Output to” on the [ThinPrint] configuration
	page to “Logical Printer 0" and avoid overruling that setting.

Intermate100 and Intermate101 Print Server Administration Manual 168