[Logical Printers 1-8]: Target Printer

20.2. Target Printer

This parameter specifies the destination of the printed output to be used in connection with the logical printer you are config- uring.

If you are not using NDO, the only possibility is to keep the default which is Local Printer (0).

If you are using NDO, you can choose among six possibilities for a given logical printer:

Older print servers

Newer print servers

 

 

Local(0)

Local Printer (0)

 

 

Netw1(1)

Network Destination 1 (1)

 

 

Netw2(2)

Network Destination 2 (2)

 

 

Netw3(3)

Network Destination 3 (3)

 

 

Netw4(4)

Network Destination 4 (4)

 

 

Pool

Pool

 

 

“Local” is also referred to as the local port and refers to the Centronics parallel port on the printer to which the Intermate1xx is physically attached.

If you choose a Network Destination which has not been defined in “Network Destination Option” [page 144], and then send a job to the logical printer in question, the job will be dis- carded and an error message will appear in the System Log (see ““Status > System Log”” [page 176]). The same thing will happen if you have defined a Network Destination, but have no NDO license key installed (G22-based print servers).

If you choose “pool”, you must also fill in the next field in the block defining the logical printer you are configuring.

Intermate100 and Intermate101 Print Server Administration Manual

152

Page 152
Image 152
Intermate 100 manual Target Printer