Configure [SNMP]: Traps

6Close the “Customize Trap Alarms” box.

7Log on to the Intermate1xx.

8Choose “Configurations > Status Monitoring” > [SNMP] to set the parameters you want.

Parameter

Default Setting

Comments

 

 

 

Monitor Community

public

 

 

 

 

Control Community

public

 

 

 

 

Trap Community

public

Set this to a value other than "public" if

 

 

you want to control who should receive

 

 

traps.

 

 

[Table is continued on the next page]

 

 

 

Trap Target

>Blank<

The receivers of traps are specified by

 

 

their IP addresses. IP addresses must be

 

 

entered with the ASCII character one as

 

 

lead-in, e.g. 1192.168.4.186

 

 

For Novell Netware under IPX/SPX (only

 

 

in G22-based servers purchased before

 

 

4 January 2002), (not applicable to

 

 

Intermate101) use the IPX/SPX address.

 

 

IPX/SPX addresses be entered with the

 

 

ASCII character zero as lead-in, e.g.

 

 

00000000400c0a20507f8

Enable Authentication

No

Set this to "Yes" if you want to enable

Traps

 

traps on attempts of unauthorized

 

 

access.

 

 

 

Enable SNMP Printer

No

Set this to "Yes" if you want to enable

Traps

 

traps on printer errors.

 

 

 

Trap on ’Off-line’

Yes

-

 

 

 

Trap on ’Out of Paper’

Yes

-

 

 

 

Trap on ’Paper Jam’

Yes

-

 

 

 

Trap on ’Cover Open’

Yes

-

 

 

 

Trap on ’Toner Low’

Yes

-

 

 

 

Intermate100 and Intermate101 Print Server Administration Manual

190

Page 190
Image 190
Intermate 100 manual 00000000400c0a20507f8