Intermate 100 LPR Print Queues LPD Protocol, Queue Name Queue Type Output is directed to

Services in “Input Control”: LPR Print Queues (LPD Protocol)

22.3. LPR Print Queues (LPD Protocol)

Pre- configured Queues

Configurable Queues

The print server supports up to 12 LPR queues.

Eight of them are configurable while four are pre-configured. Each queue is identified by the following three parameters:

1Name

2Queue type

3Where to direct the output of LPR queues See “Services in “Input Control”” [page 159].

4Remember to “Save & Cont.” and then “Reboot” to activate. The four pre-configured LPR queues look like this.

Queue Name	Queue Type	Output is directed to
PAR_B	binary (this means no	PR0 /Logical Printer 0
	conversion)
PAR_BF	binary plus form feed after the job	PR0 /Logical Printer 0
PAR_A	ASCII (also called ASCII transfer.	PR0 /Logical Printer 0
	This includes LF => LF-CR
	conversion).
PAR_AF	ASCII plus form feed after the job	PR0 /Logical Printer 0

Name:

The “name” fields for the configurable queues have been filled out with defaults LPQ1, .... , LPQ8. If you want to change a

queue name, note that it must consist of maximum 8 ASCII characters. Check the documentation for your host systems for syntactical restrictions, or observe the restrictions described on page 104.

Queue Type: Choose a queue type from the pull-down list.

Important: If you specify a name in the printing environment which is not on the [LPR] configuration page, the print server will use the pre-configured queue named PAR_B.

Intermate100 and Intermate101 Print Server Administration Manual 163