Cisco Systems ME 2400 manual 2-19, Align the SFP module in front of the slot opening

Chapter 2 Switch Installation

Installing and Removing SFP Modules

Figure 2-19 SFP Module with a Bale-Clasp Latch

86575

To insert an SFP module into the module slot, follow these steps (see Figure 2-20):

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis. Step 2 Find the send (TX) and receive (RX) markings that identify the top side of the SFP module.

Note On some SFP modules, the send and receive (TX and RX) markings might be replaced by arrows that show the direction of the connection, either send or receive (TX or RX).

Step 3 Align the SFP module in front of the slot opening.

Step 4 Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear of the slot.

Figure 2-20 Installing an SFP Module into an SFP Module Slot

Cisco ME

1

2

2400 SERIES

132691

Step 5 For fiber-optic SFP modules, remove the dust plugs from the optical ports, and store them for later use.

Caution Do not remove the dust plugs from the fiber-optic SFP module port or the rubber caps from the fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables from contamination and ambient light.

Cisco ME 2400 Ethernet Access Switch Hardware Installation Guide

OL-7678-01 2-19