Cisco Systems ME 2400 manual Connecting to a Power Source, IP Settings

Appendix D Configuring the Switch with the CLI-Based Setup Program

Connecting to a Power Source

Connecting to a Power Source

Follow these steps to connect to an AC power source:

Step 1 Connect one end of the supplied AC power cord to the power connector on a switch rear panel. See Figure D-2.

Step 2 Connect the other end of the power cable to a grounded AC outlet.

Follow these steps to connect to an DC power source. For detailed instructions for connecting to DC power, see Appendix C, “Connecting to DC Power.”

Step 1 Connect one end of the supplied DC power cord to the power connector on a switch rear panel. See Figure D-2.

Step 2 Connect the other end of the power cable to a grounded DC outlet.

When the switch powers on, it automatically begins the power-on self test (POST), a series of tests that verifies that the switch functions properly. When the switch begins POST, the system LED slowly blinks green. When POST completes, the system LED blinks amber. If POST fails, the system LED remains amber. If POST completes successfully, the system LED rapidly blinks green.

Note POST failures are usually fatal. Call Cisco Systems if your switch does not pass POST.

If you started the terminal emulation program before you powered on your switch, the PC or terminal displays the bootloader sequence. You need to press Enter to display the setup program prompt.

Entering the Initial Configuration Information

To set up the switch, you need to complete the setup program, which runs automatically after the switch is powered up. You must assign an IP address and other configuration information necessary for the switch to communicate with the local routers and the Internet.

IP Settings

You will need this information from your network administrator before you complete the setup program:

•Switch IP address

•Subnet mask (IP netmask)

•Default gateway (router)

•Enable secret password

•Enable password

•Telnet password

Cisco ME 2400 Ethernet Access Switch Hardware Installation Guide

OL-7678-01 D-5